This card is done for my Dare to Get Dirty 2021 challenge, and yes, you are right, I cannot tell you what the challenge is, but I doubt you will have too much trouble figuring it out.
To start I die cut the white cardstock with my pierced rectangle dies. I did a quick measure across the top as I wanted to use 6 colours, and not the indigo blue that is normally added.
I also did not want to colour over the piercing so measured from just inside it to just inside on the other side. With that done, using 1/8th inch masking tape I masked off the area between each colour then coloured using Copic markers.
I did not use tape on the two outside colours, and see how wonky I got on the right side, whereas the left side is fine. Sheez!
I then die cut the lattice look background pieces in black and cut and glued in place. Then in my mini Misti I stamped the floral using Memento ink, even though I was not colouring it. I did not want to worry about smears.
I added foam squares to the back of the floral image.
I then attached the white panel to my black card base using glue. I then attached the flower to the white card. For the sentiment I heat embossed it using gold embossing powder, die cut and attached to the flower.
To finish I added a few gold crystals around the card, including a small one on the sentiment banner.
You all know how much I love colour, so of course I love this card. I hope you enjoy it as well, and I thank you for your visit.
Following are Affiliate links for the products I used for this card, at no extra cost to you.
0 comments
Thank you very much for commenting. I love to read what you have to say and appreciate the time you take. I monitor comments to keep those spammers out, so do not be surprised if you do not see your comment straight away.